The function of Super heater in the thermal power plant is to
remove the last traces of moisture from the saturated steam coming
out of boiler and to increase its temperature above saturation
temperature as per requirement at inlet of steam turbine.
• Superheating raises overall efficiency as well as avoids too much
condensation in last stages of turbine which avoids blade erosion.
• The heat of combustion gases from furnace is utilised for removal
of moisture from steam and to superheat the steam.
• Super-heaters ususlly have several tube circuits in parallel with
one or more return bends,connected between headers.
• Heat from the hot gases to the vapour in the surperheater is
transferred at high temperatures.
• Therefore promary section of superheater is arranged in counterflow
and secondary section in parallel flow to reduce the temp.stressing
of the tube wall.
|Pendant-type||1.Firm structural support||1. Flow blockage by condensed steam 2. Needs slow restart to purge
the water that accumulates in the bottom.||supported from above|
|Inverted-type||1.Proper drainage of the condensed steam||1. Lack the structural rigidity, especially in high speed gas flow||Supported from below|
1. Proper drainage
2. Good structural rigidity.
|1. They do not view the flam directly so they are mainly from the
convective type||Usually supported in the vertical gas ducts parallel to the main
use for heating saturated steam, steam temperature could be up to
900 degree C.
Superheater Capacity Upgrades to Increase Power Generation
Send us required technical data, such as steam capacity, presure,
required temperature etc. We will design accordingly.
Established in 1985,Zhangjiagang Hua Dong Boiler Co.,Ltd.(trading
as HD Boiler),produces power plant; industrial; waste heat; waste
incineration; biomass; organic heat carrier and electric steam
boilers. Coupled with a comprehensive range of heating surfaces, HD
Boiler brings to the market a unique service including boiler
design , fabrication, installation, maintenance and replacement of
boiler pressure parts.
1. Fabrication area of 200,000 square meters
2. 150 Engineers
3. 600 Coded welders
4. 60 Licensed Inspectors(NDT Level-III instructors)
5. Class-A Licenses for Design and Manufacture Boiler
6. ISO 9001:2008 Quality System
7. ASME Certificate of Power Boilers
8. ASME 'S','U' and NB stamp authorization